REF.
07629
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
LOAD THE MACHINE
Make sure the trimmer is turned off.
1. Connect the appliance plug to the appliance plug.
2. Connect the adapter to a household power outlet.
Verify that the charge status lamp illuminates.
Charging is completed after approx.
1 hour.
3. Unplug the adapter when the charge status light stops glowing.
The recommended ambient temperature for charging is 0ºC-35 . Battery
performance may decrease at extremely low temperatures and the
battery may not charge properly.
A full charge supplies enough power for approximately 50 minutes of use.
The method of operation and the ambient temperature.
When charging the trimmer for the first time or when it has not been in
use for more than 6 months, the main body lamp may not illuminate for
a few minutes, or the operating time may shorten. Please charge it for
more than 8 hours in such cases.
USING THE TRIMMER
Make sure the trimmer is turned off.
We recommend using the trimmer in an ambient temperature range of
0-35 . If used outside this range, the appliance may stop working.
1. Mount desired comb attachment and adjust cutting height as needed.
(See page 11.) Can also be used without the comb attachment. (Cutting
height: about 0.5mm)
The actual length of hair will be a little longer than the height you set.
2. Press the power switch to turn on the power.
USE OF THE COMBINATION ACCESSORY
Be careful not to cut your hand with the blade when placing or
removing the comb attachment.
Make sure the trimmer is turned off.
1. Mount the comb attachment on the main body until it clicks.
Cutting height (estimate)
- Comb from 1 mm to 10 mm - for beard
- Comb from 11 mm to 20 mm - for hair
The trimming height of the body hair comb attachment cannot be
adjusted.
This comb accessory is trimmed to a length of about 1.5mm
2. Turn the dial and adjust the cutting height indication mark to the
desired height.
CUTTING BEARD
Do not use with applied shaving foam or when
the beard is wet. A wet beard can
adhere to the skin or group together, making it difficult to cut.
Beard length adjustment
Make sure the trimmer is turned off.
1. Place the beard comb attachment on the main body.
2. Set the trim height.
3. Holding the trimmer with the power switch facing up, trim by
bringing the blade into contact with the skin and moving the
trimmer against the flow of the beard.
Haircuts can accumulate inside the accessory when a large volume
of beard is cut, so discard it after each use.
Trim without comb attachment / trim soft hair
1. Remove the comb attachment.
2. Holding the trimmer with the power switch facing out, cut by brin-
ging the blade into contact with the skin.
The trimmer cannot trim hair to lengths less than 0.5mm
Beard design
Use the trimmer without any comb attachment to properly shape your
beard.
Use the precision trimmer to trim narrow areas and to trim derailment.
Above and below the lips
Holding the trimmer with the power switch on the bottom, cross-cut a
line with the blade at a 90 ° angle to the skin.
Holding the trimmer with the power switch facing the skin, cut by
bringing the blade into contact with the skin.
Trim to a uniform length
1. Place the hair comb attachment on the main body.
2. Set the trim height.
3. Holding the trimmer with the power switch up, cut by moving the
trimmer slowly against the flow of hair and toward the crown of your
head.
4. Cut slowly when crossing from various directions to avoid missing
points.
