EN
Chain saw
ATTENTION! Do not operate the chainsaw with a defective
or badly worn
cutting device.
WARNING! Familiarize yourself with the chainsaw sawing
technique in detail before use (see “Basic working
technique”).
Risk of injury! Never allow children to operate the chainsaw.
Do not allow persons to use the chainsaw, if they have not
read the operating manual or received appropriate
instructions for the safe and correct use of the chainsaw.
We recommend attending a suitable training course. The
information provided here is for supplementary purposes
only!
Before every use
• Check all parts are secure and inspect for visible defects. •
Check the device for correct chain tension.
• Test the function of the chain brake.
• Check chain lubrication.
• Check for any leaks.
Holding the device correctly
Risk of injury!
Never work on unstable ground!
• Never work above shoulder height!
• Never work when standing on ladders!
• Do not bend too far when working!
• Only use the device when the weather and terrain
conditions are favourable! • Stands with both legs firmly on
the grounds.
• Be aware of obstacles in the working area.
• During work, always hold the device tight in both hands!
How to saw correctly!
• Scan the working area and remove any interfering
objects.
• At the start of work, check that the device is safe.
• Hold the device in both hands as prescribed.
• Switch on the chainsaw before applying it to the cut.
• Exert regular pressure on the device and do not apply
excessive force.
• If possible, apply the device to the branch you wish to saw
with the claw stop.
ATTENTION!
If the cutting device touches a foreign body, or the
operation noise intensifies, or the device vibrates unusually
heavily, switch off the motor and allow the device to come
to a halt. Remove the battery and implement the following
measures:
• check for damage
• check for loose parts and fasten all parts
• replace damaged parts with equivalent parts or have
them repaired.
After use
Risk of injury!
Always switch off the device before setting the device
down. The saw chain will run on for a short time after stop
the motor, wait until all moving parts have come to a
complete standstill, remove battery,place the protective
sheath on the cutting unit,apply chain brake,leave the
device to cool down.
NOTE: After use, the battery temperature might be high,
Operation
INSTRUCTION MANUAL
and the battery would be over-temperature protected,
allow the battery cool down for half an hour and it would
recovery function
.
Basic working technique
Risk of injury!:This section examines the basic working
technique for using the device. The information provided
here does not replace the many years of training and
experience of a specialist. Avoid any work that you are not
adequately qualified for! Careless use of the device can lead
to serious injuries and even death!
Sawing technique: Pull sawing
With this technique, sawing takes place with the underside
of the guide bar from top to bottom. The saw chain pulls
the device forwards and away from the user. With this
action, the front edge of the device forms a support, which
absorbs the forces that arise on the tree trunk during
sawing. With pull sawing, the user has significantly greater
control over the device and is able to better avoid
kickbacks. This sawing technique should therefore be used
if possible.
Push sawing
With this technology, sawing takes place with the top side
of the guide bar from bottom to top. The saw chain pushes
the device backwards, towards the user.
WARNING!
If the guide bar tilts, the device may be jerked towards the
user with great force. If the user does not balance the
backward force of the saw chain with their body strength,
there is a risk that only the tip of the guide bar will remain
in contact with the wood and kickback will occur.
