4
Button 1: Remote control on/off button
A: Short press once to turn on the light, and button 2 will
take effect at the same time; B: Press again shortly to turn
off the light, and Button 2 becomes invalid;
Button 2: Induction mode conversion button
the three modes are cycled in sequence, if Use button 1
to turn off the lamp to trigger the memory function, use
button 1 to turn on the lamp again, the mode is the mode
before closing;
NOTE: The first time it is turned on, the default is MODE 1
MODE 1: Maximum Brightness Mode
The maximum brightness is 800lm, and the light will be off after heating for 3S; if
it is daytime, it will not turn on; if it is night, it will be off after warming up. When
human movement is sensed, it will light up at the maximum brightness of 800lm
for 20S, and then it will turn off after 20s, repeat the above actions; (when the
power is turned on for the first time, the heat engine time is 15S)
MODE 2: Maximum Brightness Mode + Minimum Brightness Mode
The minimum brightness is 20lm, and the light will be off after 3S warming up; if it
is daytime, it will not light up; if it is night, the brightness after warming up is 20lm.
When human movement is sensed, it will turn to the highest brightness 800lm to
light up for 20S, and turn to the lowest brightness after 20S. 20lm, sense the
movement again, repeat the above action;
MODE 3: Constant Light Mode
Medium brightness 100lm, turn off the light after heating for 3S; if it is daytime, it
will not light up; if it is night, enter the 100lm long light mode, keep on for 4 hours
under 100lm state, the motion sensor will not work; 4 hours later, switch to
MODE 1, After detecting people, the highlight mode (800lm) will go out after a
delay of 20s;
