16
ENGLISH
The insert is supplied with a base plate
(A)
complete
with smoke duct
(B)
and primary air duct
(C).
To fit, proceed as follows:
• Check for a power outlet on the back of the insert, so
that it is accessible once installation is complete.
• After evaluating the proper position of the insert, lift it
using the two handles on the sides of the insert
(D)
,
from the base plate
(A).
• Secure the base plate
(A)
on the base using
bolts through the holes positioned on the perimeter of
the plate (
X
– Fig. 4).
Alternatively, to secure the above plate, you can use
the existing holes in the same base plate (
Y
– Fig. 4)
and countersunk screws (the screw head must not
protrude more than 2 mm from the base plate).
The customer can make other holes, being careful not
to do so in line with the guides (
Z
– Fig. 4)
• Fit the flue (not supplied) on the smoke duct
(B)
and
the Ø 40 mm tube (
C1
– not supplied) on the primary
air duct
(C).
The Ø 40 mm tube (
C1
– not supplied) can be installed
from below the base plate (
A
), see Fig. 3.
• Replace the insert (Fig. 4) by sliding it on the base
plate (
A
– Fig. 2) until it stops (the insert must fit in the
two slots (
E
– Fig. 2) in the front part of the base plate
(
A
– Fig. 2), taking care that the power supply cord is
not crushed between the two plates.
INSTALLATION
fig. 2
E
A
B
C
D
A
B
C
C1
fig. 3
A
B
C
C1
fig. 4
X
X
X
X
X
Y
Z
6,5
6,5
15
15
23
INSTALLER
INDICATIVE DRAWINGS, NOT ALWAYS
REFERRING TO THE SPECIFIC MODEL.
X
fig. 1