EdilKamin Alpen, Инструкция по установке, эксплуатации и обслуживанию

Страница: 34 / 184

- 34
-
ENGLISH
COVERING INSTALLATION URAL
Ŏ
g. 1
Ŏ
g. 4
*
72
19
72
90
12
INCLUDED HARDWARE:
2 M6x25 screws
2 M6x12 screws
4 silicone spacers for ceramic top
8
ŏ
at washers M6
2 bushings
The thermo-stove comes furnished with its lateral metal
side panels already assembled, while its ceramic upper
and lower front panels (72) and top (90) must be assembled
as follows:
ASSEMBLING THE UPPER FRONT PANEL (
Ŏ
g. 1-2)
• Pull the cast iron upper grille upwards (19).
• Position the upper front panel (72) against the metallic
front panel support (12) located above the door.
• Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws (the door must be opened before
performing this operation).
NOTE:
In order to correctly install the upper front panel (72), the
supplied bushing must be positioned between it and the
metallic front panel (12), as indicated in detail “Z” (
Ŏ
g. 2).
ASSEMBLING THE LOWER FRONT PANEL (
Ŏ
g. 1-3)
• Position the front panel (72) and use an Allen key to
fasten it in place using the 2 supplied M6x25 screws as indica-
ted in detail “X” (
Ŏ
g. 3).
ASSEMBLING THE CERAMIC TOP (
Ŏ
g. 4)
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (90)
• Where necessary, af
Ŏ
x the supplied washer between the silic-
one spacer and cast iron top.
72
vite
Part. “Z”
12
Ŏ
g. 8
Ŏ
g. 9
72
72
n°2 viti
Part. “X”
bushings
screw
DETAIL. Z
2 screws
DETAIL. X
COVERING INSTALLATION ANDE/FUJI
Ŏ
g. 12
Ŏ
g. 13
*
73
72
72
n°2 viti
Part. “X”
2 screws
DETAIL. X
ASSEMBLING THE CERAMIC TOP ANDE/FUJI (
Ŏ
g. 13)
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (73)
• if necessary, insert a washer between the silicone spacer
and the cast iron top.
NOTE:
• the red enamel with crystalline, applied to the
majolica, crazes (cracks) evenly over the whole surface.
Crazing is not a defect but is a characteristic of enamel
applied to majolica known as “craclè”.
• The ceramic parts (majolica) are cast and enamelled
manually and may present small defects that will not
affect their quality (small dents or enamel porosity), but instead
testi
Ŏ
es to their manual manufacture.