Edgewater Networks 240IS, Руководство пользователя

Страница: 217 / 219

INSTALLATION INSTRUCTIONS
Step 1: If no outboard engine is mounted to transom skip to Step 3.
Step 2:
If outboard motor is mounted to transom remove outboard engine using proper lifting equipment and
procedures. Be sure the lifting equipment is rated for the necessary lifting capacity. See your local marine
dealer if unsure. Remove mounting bolts and nuts and swing motor away from boat. It should not be necessary
to remove any cables or wires as most installations have adequate length. Disconnect any wires or cables that do
not have necessary length.
Step 3:
Prepare transom for mounting by removing any silicone residue, dirt or oil. Put a fresh and generous
bead of silicone around each mounting hole. Mount Atlas jack plate to transom (shortest side 12 ½” long) using
bolts and nuts from engine removal. It is necessary in our installation that the bolts go through the Atlas jack
plate then through the transom. The nuts attach to the bolts inside the transom. We recommend use of a
transom support plate for both the top and bottom mounting bolts, thus eliminating nuts and washers from
becoming embedded into transom.
(Photo below: Available from your marine dealer)
* NOT INCLUDED (OPTIONAL)
When mounting the Atlas to your transom you will note there are three sets of mounting holes in the jack plate.
Because transoms are different, three mounting hole patterns are pre-drilled . You choose which best satisfies
your transom. However, make sure that you use same holes on both sides, so jack plate will set level.
Step 4: Before mounting engine, the wiring harness will need to be hooked up. Locate desired position for
“Up & Down” rocker switch. Cut 1 ½” x 1” rectangle hole taking care to check for any wires, brackets or cables
behind dash for the switch to pass through. However, do not install switch at this time.