EdgeStar DWP62BL, Руководство по обслуживанию

Страница: 54 / 56

53
Troubleshooting
SYMPTOM CHECK FOR THE FOLLOWING REMEDY
E1 Error Code
Dishwasher will not
fill with water or will
not fill properly
The water supply is turned off Turn the water supply on
Defective water inlet valve Replace the inlet valve
Low water pressure Minimum water pressure of 20 PSI
Obstructed water inlet valve or hose
Disassemble and clean the water inlet valve
and hose
Defective air breaker Replace the air breaker
Heavy water usage elsewhere in home
Use dishwasher when water usage is at a
minimum
Defective PCB assembly Replace the PCB assembly
Dishwasher will
not drain
Defective drain pump Replace the drain pump
Obstructed drain hose Check the drain hose
Defective PCB assembly Replace the PCB assembly
E3 Error Code
Dishwasher runs but
will not heat
Possible low input voltage Ensure power requirements / power supply in
“Specifications” section
Defective temperature sensor Replace the temperature sensor
Defective heating element Replace the heating element
Defective PCB assembly Replace the PCB assembly
E4 Error Code
Overfill alarm
Defective micro-switch for float Replace the micro-switch
Defective PCB assembly Replace the PCB assembly
Water leaks from dishwasher
See “Water leaks from dishwasher”
Does not operate
when Start button
pressed The door not close properly Confirm door closed properly
Defective door switch contacts Replace the door switch
Defective door latch Replace the door latch
Defective PCB assembly Replace the PCB assembly
Too little water fill Dishwasher not level Level the dishwasher
Defective air breaker Replace the air breaker
Water siphons out Clean or Replace the Air Breaker
Dishwasher runs with
door open Defective door switch contacts Replace the door switch
Defective door latch Replace the door latch
Defective PCB assembly Replace the PCB assembly
Motor will not start or
run
Defective motor bearings Replace the motor
Defective motor capacitor Replace the motor capacitor
Improper motor voltage Replace the motor
Motor windings shorted Replace the motor
Improper motor voltage Replace the motor
Defective motor capacitor Replace the motor capacitor
Cycles repeat in error Defective PCB assembly Replace the PCB assembly