5
Electrical Requirements
Failure to follow electrical requirements can cause personal injury, fire, or
electrical shock. Install the Combo Washer/Dryer according to the
manufacturer’s
instructions and follow and state or local building codes
that may apply. To reduce the risk of severe injury or death, follow all
installation instructions. Save these instructions even after installation is
complete for future reference.
•
This unit must be connected to a properly grounded outlet in
accordance with all local codes and ordinances. If there is a short
circuit, proper grounding can reduce the danger of electrical
shock.
•
It is the responsibility and obligation of the product owner to have
a proper outlet installed by a qualified electrician.
•
This washer is equipped with a grounded 3 prong plug.
•
Do not remove ground prong. Do not use an adapter or extension
cord. Plug into a grounded 3 prong outlet.
•
Do not overload the outlet with more than one appliance.
Location Requirements
Selecting the proper location for your washer improves performance,
minimizes noise, and helps prevent possible washer
“
walk
”.
Your washer
can be installed under a custom counter, or in a basement, laundry room,
closet, or recessed area. Proper installation is your responsibility.
You will need:
•
A water heater set to deliver 120°F (49°C) water to the washer.
NOTE: This appliance will heat water to the appropriate
temperature if a hot water source is unavailable; however, this will
increase the energy consumption by this appliance.
•
A grounded electrical outlet located within 6 ft. (1.8 m) of where
the power cord is attached to the back of the washer.
•
Hot and cold water faucets located within 4 ft. (1.2 m) of the hot
and cold water fill valves, and water pressure of 20 - 120 psi (137.9 -
689.6 kPa).
•
A level floor with a maximum slope of 1" (25 mm) under entire
washer.
•
Washer should be installed on a rigid, dry, and level surface. Soft
floor surfaces such as carpets or surfaces with foam backing are
not recommended.
•
A sturdy and solid floor to support the washer with a total weight
(washer, water, and load) of 320 lbs.
•
Store and install the washer where it will not be exposed to
outdoor weather conditions.
•
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
•
Avoid direct sunlight and make sure there is sufficient ventilation.
•
Keep far away from heating fuel sources such as propane or
natural gas.
WARNING:
Connecting this
appliance to an improperly
grounded outlet can result in
risk of electric shock. Check
with a qualified electrician if
you are in doubt as to
whether the outlet is properly
grounded. Do not modify the
plug provided with this
appliance - if it does not fit
the outlet, have a proper
outlet installed by a qualified
electrician.
Refer to the “Electrical
Safety” section found at the
beginning of this user manual
for additional considerations
related to the electrical
connection required to
operate this appliance.
