EDGE 540-V3 55cc Item code: BH92-A
.
Instruction Manual
4
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole
on the aileron servo tray / hatch. This hole will allow
the servo arm to pass through when installing the
aileron pushrods.
1. INSTALLING THE AILERON SERVOS
Drill a hole
1.5mm
Servo tray
Remove the covering
Aileron
Bottom side
1. Aluminium landing gear.
3. Plastic parts for landing gear.
4. Wheel pants (left & right).
5. Spinner.
6. Fuel Tank.
8. Wheels.
9. Rudder plastic light.
11. Tail gear set.
I. SERVO
2x12mm
3x12mm
5x70mm
4x12mm
3x10mm
REPLACEMENT SMALL PARTS
11
5x50mm
6x20mm
6
5
1
4
8
8
9
3
