20
Chevy/GM Attitude Getting Connected
The
Attitude
monitor connects under the hood to the Edge
Juice
module.
Follow these steps to install the
Attitude
:
1. Place your
Attitude
monitor on the dash of your vehicle approximately
where you want it installed and, with the driver’s door open, feed the cable
through the open door, and into the engine compartment via the slot near the
hood hinge.
2. Determine where you want to attach the
Attitude
mounting bracket and
insert it into your dashboard. The bracket fits well in the seam of the dash
board by separating the seam slightly and sliding in the bottom portion of the
bracket until it snaps into place
(see figure 1)
. The following pictures
demonstrate how to best mount the Attitude with the new bracket.
Figure 1
Figure 2
3.
Connect the
Attitude
to your Edge
Juice
module by snapping together the
cables with the green connections
(see figure 3)
. Secure any excess cable to
prevent entanglement with moving engine parts.
The bracket fits well in
the seam of the dash
board by separating the
seam slightly and sliding
in the bottom portion of
the bracket until it snaps
into place.
After the bracket is
mounted, use the supplied
two sided tape to secure
the Attitude to the bracket
