Edge Technologies Patriot 338, Руководство по эксплуатации, Страница: 39 / 272

PATRIOT
338/551
33
REV 10:2019
3. Thread the 8 arbors into the stand holes until contact with the floor is achieved.
4.
Caution do not allow the bar feeder to achieve an angle greater than
10 degrees to the floor. This could cause the bar feeder to fall over.
Continue to thread the arbors located at the 4 end points a few thread turns at a time. It is
important to maintain less than 10 degrees tilt to the floor.
5. Once 3 inches from the inner stand to the floor is achieved place the supporting level pads in
place and thread the arbors into the level pads. Thread the arbors so the weight of the bar
feeder is supported by the inner level pads.
6. Place a small level with a magnetic base on the top of the electrical cabinet. Adjust the center
arbors to level the bar feeder.
7. Determine the distance from the floor to the center of the spindle of the lathe. Compare this
dimension to the distance from the bottom of the bar feeder stand to the center of the opening of
the steady device plus 75mm. If this distance is not within 25mm ± of the lathe center height the
bar feeder stands must be adjusted by repositioning the legs on the bar feeder stands. The
spacing between the holes of the legs are 35mm. The legs can be adjusted without use of a
crane or lift truck by supporting the stand with one set of arbors and level pads while moving the
opposite set. The height adjustment need not be exact at this point. The final adjustment will be
made during the alignment to the lathe.
1. Loosen 4 locking screws on the side
of the stands (1)
2. Adjust the screw (2) up or down to
achieve correct height. Adjust the bar
feed height to center the channel to
the lathe spindle.
Tighten screw (1) when alignment is
completed.