Edge Products ______________________________________GM Juice-Attitude CS/CTS
22
5.
Run the cable up under the dash. Open the driver’s side door, and remove the access
panel on the left side of the dashboard. (The panel will typically unsnap when the
bottom is pulled out.) Remove fasteners if required, and route the cable behind the
panel and up to the A-pillar. Replace the screws, and access panel. The cable will
protrude from the dashboard up along the A-pillar and be able to move freely when
pulled.
WARNING Secure excess cable under the dash with supplied nylon ties. Ensure
excess cable does not interfere with pedal or other mechanical linkage during operation of
the vehicle.
6.
With roughly 8 to 10 inches of the EGT cable extending above the dashboard, plug the
6-pin connector into the accessory port on the back of the CS/CTS device.
Route cable along and
under the door seal,
and around the bottom
of the A-Pillar
