Edge Ovens EDGE40, Инструкция по установке и эксплуатации

Страница: 24 / 48

EDGE40 / EDGE60 Installation and Operating Manual
20 Rev 1.1 December 04, 2008
1. Conveyor installation is easier to perform using two people. Unfold the conveyor
and lay it flat on the floor. Secure the hinge locking mechanism with the screws
provided in the hardware kit. (
Installation Instructions – Conveyor (Options #1 and #2)
Figure 19)
Figure 19
2. Working from the drive side of the oven, gently set the non-drive end of the conveyor
into the bake chamber between the upper and lower end plugs.(Figure 20)
Figure 20
3. Tilt the conveyor upward slightly and slide the conveyor through the bake chamber
until the far end starts out the opposite side of the bake chamber.
4. Lift the conveyor from both ends and slide it through the bake chamber slightly past
its control side stops. This allows room to attach the conveyor drive chain over the
drive sprocket.(Figure 21)