Align Antennas
4-9
4
The RSSI connector provides an output voltage between 0 and 3.28 VDC that is
proportional to the received radio signal strength. The higher the voltage reading,
the stronger the signal. The radio signal from the remote antenna can be seen to
have a strong central main lobe and smaller side lobes. The object of the alignment
process is to set the antenna so that it is receiving the strongest signal from the
central main lobe.
To align the antennas in the link using the RSSI output voltage, start with one
antenna fixed and then perform the following procedure on the other antenna:
Note:
The RSSI output can be configured through management interfaces to output a
value for specific WDS ports.
1.
Remove the RSSI connector cover and connect a voltmeter using a cable with
a male BNC connector (not included).
Main Lobe
Maximum
Horizontal Scan
Vertical Scan
RSSI
Voltage
Side Lobe
Maximum
RSSI Voltage
Remote
Antenna
Maximum Signal Strength Position
for Horizontal Alignment
Maximum Signal
Strength Position for
Vertical Alignment
Содержание OAP6626A
