Edge-Core ES4704BD, Руководство пользователя, Страница: 76 / 93

66
snap into place at the bottom of the line card.
Note: the SFP 1000BASE fiber transceiver is hot swappable.
Do not stare directly at the 2 fiber bore in the SFP 1000Base fiber transceiver when
the switch is in operation. The laser may hurt your eyes.
2.3.6 XENPAK transceiver installation
In the ES4704BD, Each EM4700BD-2XG-XENPAK line card provides 2 XENPAK
10GB fiber transceiver slots. The procedure for installing the XENPAK 10GB fiber
transceiver is shown below:
Step 1: Put on an ESD wrist strap (or antistatic gloves)
Step 2: Insert the XENPAK transceiver onto the guide rail inside the 10GB line card. Do
not put the XENPAK transceiver up-side-down.
Step 3: Push the XENPAK transceiver along the guide rail gently until it comes into
contact with the front panel of the 10GB line card.
Step 4: Tighten (clockwise) the panel fasteners in the front of XENPAK transceiver until
fastened to the front panel of the 10GB line card.
Note: the XENPAK 10GB fiber transceiver is hot swappable
Do not stare directly at the 2 fiber bore in the XENPAK 10GB fiber transceiver when
the switch is in operation. The laser may hurt your eyes.
2.3.7 Copper Cable/Fiber Cable Connection
Ethernet cable connection:
Step 1: Insert one end of the Ethernet cable into the RJ-45 Ethernet port in the switch
copper cable line card
Step 2: Insert the other end of the Ethernet cable into the RJ-45 Ethernet port of the
other device
Step 3: Check all status indicators for the corresponding ports, a lighted LINK indicates
the link has been established, otherwise the link is not ready and the cable
should be examined
Upon connection, please verify the sign above the port to avoid use of other ports,
which might damage to the modules or the switch.
Notice
Notice
Notice