Edge-Core ES3628C, Руководство по управлению, Страница: 597 / 674

IP Routing Commands
4-271
4
Default Setting
Disabled
Command Usage
• This command can be used to advertise routes between areas.
• If routes are set to be advertised, the router will issue a Type 3 summary LSA
for each address range specified with this command.
• This router supports up 64 summary routes for area ranges.
Example
This example creates a summary address for all area routes in the range of 10.2.x.x.
area default-cost
This command specifies a cost for the default summary route sent into a stub or
not-so-stubby area (NSSA) from an Area Border Router (ABR). Use the
no form to
remove the assigned default cost.
Syntax
area area-id default-cost cost
no area area-id default-cost
• area-id - Identifier for a stub or NSSA, in the form of an IP address.
• cost - Cost for the default summary route sent to a stub or NSSA.
(Range: 0-65535)
Command Mode
Router Configuration
Default Setting
1
Command Usage
• If you enter this command for a normal area, it will changed to a stub.
• If the default cost is set to “0,” the router will not advertise a default route into
the attached stub or NSSA.
Example
Related Commands
area stub (4-274)
Console(config-router)#area 10.2.0.0 range 10.2.0.0 255.255.0.0 advertise
Console(config-router)#
Console(config-router)#area 10.3.9.0 default-cost 10
Console(config-router)#