Edge-Core ECW5212, Руководство по управлению

Страница: 31 / 48

Chapter 4
| Wireless Settings
Basic Settings
– 31 –
◆
SSID — The name of the basic service set used by a VAP interface. Clients that
want to connect to the network through the access point must set their SSID to
the same as that of the access point’s VAP interface. (Default: ACN0.# (where # is
0-7) for 5 GHz, ACN1.# (where # is 0-7) for 2.4 GHz; Range: 1-32 characters)
◆
VLAN — Wireless clients are assigned to the VLAN for the VAP interface to
which they are associated. The access point only allows traffic tagged with
correct VLAN IDs to be forwarded to associated clients on each VAP interface.
(Default: 1; Range: 1-4095)
Note: Be sure to configure the attached network switch port to support tagged
VLAN frames for the VLAN IDs configured on the access point. Otherwise,
connectivity to the access point will be lost.
◆
Hide SSID — Removes the SSID from beacon frames. Also known as network
cloaking, this security measure is less effective than using WPA or WPA2. There
are many tools that allow you to “find” the supposedly “hidden” network name.
(Default: Off )
◆
Encryption Settings — The encryption options are described under Step 1 in
the Introduction. (Default: No Encryption)
◆
Enable Bandwidth Control — Enables rate limiting of traffic to and from the
VAP interface as it is passed to and from the wired network. You can set a
maximum rate in Kbytes per second. (Range: 0 (unlimited) or 512-1024000
Kbytes per second; Default: OFF)
◆
MAC Filter Enable — Wireless clients can be authenticated for network access
by checking their MAC address against a local database configured on the
access point. (Default: OFF)
■
MAC Filter Rule — The MAC list can be configured to either accept or deny
network access to specified clients. (Default: Deny)
■
MAC Filter Address — Enter a physical address for each client. Enter six
pairs of hexadecimal digits separated by colons. For example,
00:90:D1:12:AB:89.