– 2 –
Caution:
The earth connection must not be removed
unless all supply connections have been disconnected.
Attention
: Le raccordement à la terre ne doit pas être retiré
sauf si toutes les connexions d’alimentation ont été
débranchées.
Caution:
The device must be installed in a restricted-access
location. It should have a separate protective earthing
terminal on the chassis that must be permanently
connected to earth to adequately ground the chassis and
protect the operator from electrical hazards.
Attention
: L'appareil doit être installé dans un
emplacement à accès restreint. Il doit comporter une borne
de terre de protection distincte sur le châssis, qui doit être
connectée en permanence à la terre pour assurer une mise
à la terre adéquate du châssis et protéger l'opérateur des
risques électriques.
4. Connect Power
a. Connect AC Power
Plug the AC power cord into the socket on the rear of the
switch.
Connect the other end of the power cord to an AC power
source. Verify that the external AC power requirements for
the switch can be met as listed below:
ECS2100-10T: AC 100-240 V, 50-60 Hz, 0.5 A
ECS2100-10P: AC 100-240 V, 50-60 Hz, 2.1 A
ECS2100-28T: AC 100-240 V, 50-60 Hz, 0.5 A (Not for China),
AC 100-240 V, 50/60 Hz, 0.5 A
ECS2100-28P: AC 100-240 V, 50-60 Hz, 3.2 A
ECS2100-28PP: AC 100-240 V, 50-60 Hz, 5.8 A
ECS2100-52T: AC 100-240 V, 50/60 Hz,1 A
ECS2110-26T: AC 100-240 V, 50/60 Hz,1 A
Warning:
For the ECS2100-10P, the bottom of the
enclosure is a hot surface. Do not touch!
Attention:
Pour l'ECS2100-10P, le bas du boîtier est une
surface chaude. Ne pas toucher!
Note:
For International use, you may need to change the AC
line cord. You must use a line cord set that has been
approved for the socket type in your country.
b. Connect DC Power to ECS2100-10PE
1
1
2
1
Note:
The ECS2100-10PE includes an AC-DC power adapter.
Connect the AC-DC power adapter to the switch and to an
AC power source. The AC-DC adapter provides 54 VDC,
1.67 A of power to the switch.
Plug the DC power cable into the socket on the rear of the
switch.
Plug the AC-DC power adapter into a nearby AC power
outlet.
5. Verify Switch Operation
Verify basic switch operation by checking the system LEDs.
When operating normally, the Power and Diag LEDs should
be on green.
6. Perform Initial Configuration
Connect a PC to the switch console port using the included
console cable.
Configure the PC’s serial port: 115200 bps, 8 characters, no
parity, one stop bit, 8 data bits, and no flow control.
Log in to the CLI using default settings: Username “admin”
and password “admin.”
Note:
For further information on switch configuration, refer
to the
Web Management Guide
and
CLI Reference Guide
.
7. Connect Network Cables
1
2
1
3
1
2
1
2
3
2
1
Quick Start Guide
