EdenPURE namath, Руководство по эксплуатации продукта

Страница: 4 / 12

4
MAINTENANCE & CLEANING
• Always allow the unit to cool completely before cleaning.
• DO NOT clean ceramic core or burner box.
• DO NOT use abrasive cleaners or cleaning pads
on the outside of your cooker.
• Wash your cooker with warm soapy water, and then
rinse with clean water. Use the same steps to clean
the grease tray after removal from the cooled unit.
• Grates and internal burner tubes may be cleaned
with a stainless steel bristle wire brush. Use a soft
bristle brush for stubborn debris on the outside
of the unit to prevent scratching.
• Stainless steel cleaner may also be purchased.
For best results, always clean with the grain of
the stainless steel and use only a soft cloth.
• DO NOT use aluminum foil. Disposable trays
are available (see pg. 9 to order replacements).
• Cleaning is important to avoid grease fires.
• DO NOT use water on a grease fire. Personal injury
may result. If a grease fire develops, turn knob off
and disconnect Liquid Propane tank.
REMOVING AND INSERTING
THE DRAWER
Removing the drawer:
1. Slide drawer into closed position.
2. Lift the drawer upward with rear end angled up
to unlock the wheels from tracks.
3. Pull drawer out of unit.
Inserting the drawer:
1. Place drawer over rails and slowly slide into
closed position.
2. Allow wheels to set into slots in the rear
of railings for secured position.
Inserting the drawer latch:
For your convenience, the Namath Rapid Cooker
includes a drawer latch. This latch is designed to
keep the drawer from sliding open on bumpy car rides
or when it’s being carried from one place to another.
To insert the drawer latch, please follow these steps:
1. Remove the drawer from unit.
2. Remove the steel grate from the top of the drawer
(See Figure 1).
3. Acquire the front piece of the drawer, two screws
(included) and the drawer handle.
4. Make sure the front of the drawer is positioned
with the latch down.
5. Position the screws, the front of the drawer and the
door handle so that they all line up with the two holes
cut into the drawer handle. (See Figure 2).
6. Screw the two pieces together.
BATTERY INSTALLATION/
REPLACEMENT
• To replace or install the battery, first unscrew the ignitor
knob on the front of the unit. Next, insert the AA lithium
battery (included), negative end first.
ATTACHING REGULATOR
& PROPANE TANK
• Attach regulator to thread on right side (See Figure A)
and propane (not included) to the regulator
(See Figure B).
• All other items ship fully assembled and ready for use.
Figure A Figure B
Figure 1 Figure 2
Latch on
the Bottom
If a gas leak cannot be stopped, or a fire
occurs due to gas leakage, call the fire
department.
DANGER