PARTS AND FEATURES
NOT RECOMMENDED FOR
Basements • Garages • Sheds • Rooms with Vaulted Ceilings • Construction Sites
Outdoor Areas • Any Non-Insulated Area
READ ALL INSTRUCTIONS bEFORE USING THE HEATER
1.
We recommend keeping the packaging for off-season storage and for any transportation needs.
2.
Find a level and unobstructed location to place the unpackaged heater.
3.
Do not plug in or run any appliances on the same circuit that the heater is on.
4.
Plug the power cord directly into an unused, grounded outlet.
Used to turn power to the unit on and off.
Used to turn the heater on and off. This will only work if the master power switch (shown above) is on.
Used to increase the desired temperature.
Used to decrease the desired temperature.
Used to switch between LOW and HIGH modes.
a. LOW MODE: In low mode, the heater runs on a lower wattage in order to use less electricity.
Running the heater in low mode can sometimes be more beneicial in smaller rooms where less heat is necessary.
b. HIGH MODE: In high mode, the heater consumes more wattage but also produces more heat.
High mode is recommended for larger rooms that are harder to keep warm.
IMPORTANT: To turn the heater off, press the “POWER” button; the fan will continue to run
until all of the heat has been expelled. This could take up to 3 minutes in some cases.
DO NOT UNPLUG WHILE RUNNING.
WASHAbLE LIFETIME FILTER SYSTEM
CopperSMART 1000
TM
heaters come with a washable lifetime ilter that is easy to clean.
IMPORTANT INFORMATION:
If you have allergies and/or are sensitive to dust, you will want to use this ilter. When choosing to use the
ilter, it must be cleaned as often as necessary; a clogged ilter will prevent the heater from working to its fullest capacity. If the heater
is used in an extremely dirty or dusty area, the ilter must be cleaned more frequently to keep it from clogging.
To clean the ilter:
1. Release the ilter. (See pictures)
2. Run warm tap-water over the ilter in the opposite direction of air low, until the water runs clear.
The ilter might excrete some iltered residue so be cautious not to drip on any stainable surfaces such as carpeting. You can
also soak the ilter in water mixed with a small amount of mild dish soap.
3. Shake the ilter over a sink until excess water is removed and allow it to air dry completely before
reinstalling.
DO NOT force the ilter to dry using any alternative methods.
4. Reinstall the ilter to the rear of the unit by positioning the ilter back in place and securing the ilter back into the locked position.
1. Place your
ingers on the
bottom of the
ilter and press
upward to
release the ilter
from resting on
the two tabs.
2. With the ilter
lifted off of
the tabs, pull it
toward you to
release it.
