edenox DCN-55, Руководство пользователя

Страница: 9 / 35

3
edenox.com
ENGLISH
2.1 GENERAL INFORMATION.
The plate/basket distributor should be unpacked, installed and tested by qualified service
personnel. After bringing it into the room where it is going to be installed, the device should be left for
approximately 3 hours so that it reaches the ambient temperature. Then it can be connected to power
supply.
The conductor cross - section area of the power cable for the DPC - 28 and DPC - 34 distributors
should not be smaller than 1.5
mm
2
(recommended cable - PCG 3 x 1.5
mm
2
).
The power switch should be connected directly to the power terminal (electric cabinet), while
making it possible to safely and reliably disconnect all phases powering the device. When the circuit is
broken, the gap between the jumpers of the switch should not be smaller than 3
mm .
After installation, the device must be checked for leakage conductance. The value of leakage
conductance per 1
kW
of the power of the device should be lower than 1
mA
.
WARNING!!!
If an equipotential bonding bar is required, its connections must be checked.
2.2 TRANSPORT, LIFTING, UNPACKING, STORAGE.
Correct and safe transport:
• use equipment appropriate for the weight and structure of the devices;
• cover corners and sharp edges;
Before carrying:
• secure the area against unauthorised personnel;
• make sure that the load is properly secured;
• check all loose components lest they should fall when being lifted;
• try to lift the load as vertically as possible so as not to make any dents in it;
• while carrying the load, make sure that it is as near the ground as possible.
2.3 INTENDED USE AND LIMITATIONS.
Plate distributors are used to store, transport, distribute and heat plates. The maximum load
of the distributor is 40 - 45 plates and 45kg.
The basket distributor is used to store, transport, and distribute the baskets of industrial
dishwashers as containers for tableware. The maximum load of the distributor is 5 - 6 baskets 1100 mm
deep and 120 kg.
Before using the plate heating distributor, check the electrical system for efficiency and
reliability.
After work, set the power control to 0 (see Figure 1, ‘
Point 0’
).