11
INITIAL SET UP
Before turning your WTX1000N ON, you must first determine which mode of
operation you wish to use. It is
critical
to the safety of your unit that you
make all connections correctly, and that you set the switches to the proper
position. Failure to do so may result in damage to your amplifier and or speakers!
Connect the appropriate cables to the various outputs on the back panel.
Check to make sure the front-panel switches are set for your desired mode of
operation.
In Bi-Amp mode, use the Crossover control to determine which frequencies
will go to the speakers. Because bass frequencies require far more power to
reproduce than treble frequencies, we suggest that you start out low (or left)
on the dial. But its only a suggestion. We gave you a crossover control so
you could make your own decision.
If necessary, us the Balance control to balance the volume between the low
and high speakers.
GETTING A GREAT TONE
As bassists, each of us has in our head a concept of our perfect sound. Eden
amplifiers are designed to help you easily achieve the sound you hear inside
you. However, its a multi-step process as explained below.
In order to ensure the ultimate in tone, its important to follow the procedure
outlined below. Dont skip steps; dont jump around. Yes, this may take a
minute or two, but the work is well worth it. Once theyve done it a few
times, most users can do it time and again in about a minute.
IMPORTANT NOTE
: Before you plug in your unit for the first time,
please do the following things
.
First, turn the power switch to the OFF
position. Check the back of your unit for the correct voltage notation for
your county of operation.
All manuals and user guides at all-guides.com
all-guides.com
