6
Bridge Mono Select
The WTB1000 has two separate amplifiers. They can
be used in Dual Mono or Stereo Mode, or can be bridged together to create
one, high-power amp. To engage Bridge Mono operation, depress this
switch. The indicator light will come on when in this mode.
NOTE:
Choose the mode of operation while the amplifier is OFF.
Mains On/Off Switch
This switch turns the system power ON or OFF.
The switch illuminates to indicate the presence of AC power present in the
chassis. This switch is prior to the fuse.
The switch light can be on even if
the fuse is blown.
The light in the switch may flicker depending on local
voltage conditions. This is normal and nothing to be concerned about.
DC Power On Indicator
Lights to indicate that there is power throughout
the entire amplifier.
Output Limit Indicators
Light to indicate activity of the power amplifier
limiting circuits, which protect the speaker system(s) from severe distortion.
These LEDs indicate that the amplifiers have reached their maximum output
level.
Headphone Output/Slave Output
You can use this output for silent
practicing your neighbors will really appreciate this feature or to power
another amplifier. This output is controlled by the Master Vol ume so that
you can control the entire rig with a single volume control.
Graphic EQ Section
This section contains a traditional 9-band Graphic EQ.
Each of the 9-bands boost or cut the signal 12dB. The center frequencies are
31Hz, 63Hz, 125Hz, 250Hz, 500Hz, 1KHz, 2KHz, 4KHz, 8KHz. The selector
switch to the right of the 8KHz slider enables or disables the circuit. The LED
turns on when the switch is pushed in to indicate the circuit is active.
