Eden Navigator WP-100, Быстрый старт

Страница: 8 / 68

8 | H I F I D E L I T Y F O R L O W F R E Q U E N C Y
E D E N | W O R L D T O U R S E R I E S |
B E F O R E Y O U P L U G I N - 4
BEFORE YOU PLUG IN
Before you plug in and switch on your amplifier please ensure you understand how to correctly operate your unit.
Incorrect operation may lead to undesirable results or unit failure.
IMPORTANT: All World Tour Amplifiers are designed to be mounted and operated inside a rack unit and will also operate
outside of a rack. Eden recommended they are installed to a suitable rack unit leaving a minimum of 2U free space above
each amplifier to allow adequate ventilation. We also encourage that where an environment is particularly demanding such as
under excessive stage lighting or in a very hot studio that additional cooling is employed to disperse heat.
Ensuring correct loading (WT550 and WT800 models):
When operating your unit ensure that you always use a suitable speaker load. Different loads will change the
output power of your amplifier, unbalanced loads or unacceptable impedances may damage you cabinets or the
amplifier itself. Advice on cabinet loading is included with all Eden Cabinets.
Operating without loads (All models):
Even though our Wold tour amplifiers are designed to perform on stage they are equally capable as a studio or
practice tool. To operate without a load simply take your signal from the DI output or through a set of Headphones.
Operating in Bridge Mono (WT800 Only):
Running your amplifier in bridge mono will increase the output of the amplifier by bridging both power amplifiers
inside the unit to run a single output signal. To enter Bridge Mono correctly and safely you should follow the
following instructions. INCORRECT USE OF BRIDGE MONO WILL CAUSE YOUR AMPLIFIER TO FAIL.