Electrical Section
For maximum electro-luminescent life, do not wire lighting to direct ignition switched 12-volt source. The lighting power
source should be routed through OEM dash control, or a separate rheostat. Power can be achieved by tapping into the
factory dash lighting through either the fuse panel or from a 12 volt dash light wire. This will allow you to control the light
intensity. Use the appropriate connectors for your particular application. Connectors are not included due the vast
number of applications. The white wire MUST be connected to the power source and the black wire to a good ground.
Damage to electronic circuit could occur if connected incorrectly.
NOTES:
•
If gauge mounting is other than in-dash or under dash, mounting provisions may have to be determined by the
installer.
•
Test all fittings and hoses for any leakage. If any leaks are detected, determine the cause of the leak and repair.
Do not operate vehicle if any leaks are detected.
Bill Of Materials
Qty.
Description
1
0-1400 psi Nitrous gauge
1
Gauge light with harness
2
Star washers
2
Attaching screws
1
Gauge bracket
1
Red light cover
1
Green light cover
1
Special restrictor fitting
1
Female AN adapter
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line (800) 416-8628
Tech Hours: 7:00 am—5:00 pm PST, Weekdays
©2000 Edelbrock Corporation
Rev. 7/21/00
