COPYRIGHT©EDECOA, ALL RIGHT RESERVED,PSW-EU-V2.7------English
6 / 15
When using the power inverter outdoors, please connect it to the negative terminal of the battery. It will not affect the
normal working of the power inverter without connecting the ground wire.
6. Please pay attention when the power inverter works for the main power system in RV or at home
When the power inverter is connected to the RV power system or home power system for power supply, the inverter could
be damaged If the shore power or alternator is connected at the same time by mistake when the power inverter is working.
The AC input voltage is not accepted by the power inverter.
To prevent this case, we recommend installing a Dual Power Automatic Transfer Switch (ATS).
The ATS mainly used for testing whether normal(N) or spare(R) power is normal or not. Here is the compatible
specification:
1
2P;
②
230V/50HZ;
③
Travel switch includes shutdown function
ON (R )-OFF-ON(N),
Here is the schematic diagram of RV power system.
Note:
1. The ATS must contain an intermediate disconnect setting to prevent the generator or grid from being connecting at the
same time as the inverter, resulting in the inverter being burnt.
2. The switching time of the ATS is 1-2s, and the electrical device will stop working in a short time.
7.
ABOUT THE REMOTE CONTROLLER
Tips:
The switch of the remote control and the switch of the inverter is parallel.
Therefore, when any one controls the inverter, the other switch must keep the "OFF" state.
According to different models, we have two models of remote control (ED-RC, ET-RC). However, it is not possible to
replace each other.
