Eddyfi Technologies M2M MANTIS, Техническая документация инструкция

Страница: 21 / 27

21
10. GLOBAL WARNINGS
Do not use the device for purposes other than those for which it was designed.
Do not inspect parts of the human body or animal body with MANTIS.
The use of non-compatible devices can cause device failure.
To avoid personal injury or property damage, do not disassemble, modify or attempt to repair the unit.
Carefully read the instructions in the user manual before turning the unit on.
Obey all safety warnings on the unit and those contained in the User Manual.
Do not install substitute parts or do not make modifications not allowed on the device.
Repair instructions, if any, are for technical staff qualified. To prevent dangerous electric shock, do not perform any repair unless qualified to do it. For
any problems or question about this product, please contact EDDYFI NDT or an authorized representative of EDDYFI NDT.
The deterioration of the MANTIS screen is not covered by the guarantee.
Before turning on the power, connect the ground of the device to the protective conductor of the power cord (sector). The plug must be inserted only
into a mains socket outlet with contact ground. You should never cancel function protection using an extension cord (power cable) without a protective
conductor (grounding).
When the protective grounding seems corrupted, you must power down the unit and prevent unintentional operation.
The device must only be connected to a power source of the type described in the Technical document.
Prior to trash MANTIS, make sure to comply with local laws.
In accordance with European Directive 2002/96 / EC on waste electrical and electronic equipment (WEEE), this symbol indicate that the product
should not be disposed with municipal waste but must be part of a separate collection. Please consult your EDDYFI NDT local representative for
instructions on returning the unit or find feasible collection arrangements in your country.
To have unconnected connectors IP certified, it is important to install rubber protectors of the unit before proceeding with cleaning the housing.
Otherwise, the liquid may get into the slots or flow into the housing and damage the electronics boards.
The probes connected to the MANTIS must be equipped with reinforced insulation.