VT100 Vertical Crawler™
Document: UMAH000514.docm
Revision: A14
Created by: PJ
Date: 05 Dec 2019
3029669-A14
Source Location: C:\ePDM\ISLEng\products\ah-versatrax100\manuals\UMAH000514.docm
Page 17 of 28
User Ma
nual
Expansion Range
Base Configuration
The Versatrax100
™ Vertical Crawler chassis comes standard configured for 200 – 300 mm (8 – 12in)
pipe, the
Microtracs™ are connected directly to the expansion linkages as illustrated below using the side
mounting holes. Note all tracks are connected to the linkages in the same way, whether right or left.
To reconfigure the vehicle back to the standard configuration, do the following as shown below:
1. Connect the front follower linkages using M6 x 8 mm shoulder screws with plastic spring washers
beneath the heads.
2. Connect the rear follower linkages using M6 x 8 mm shoulder screws with plastic spring washers
beneath the heads.
3. Connect the drive linkages last using M6 x 20 mm shoulder screws.
4. Connect the track connector
–
make sure to align the mating pins correctly
.
5. Repeat this procedure for each of the other two tracks.
Track removal is the opposite of installation
