9
EN
When You Are Finished
Binding Troubleshooting
14
15
16
Power off the transmitter
and video monitor
BIND
ON OFF
BATT MOTOR
Remove and recharge the
vehicle battery
Power off the vehicle
Binding is the process of programming the receiver
to recognize the GUID (Globally Unique Identifier)
code of a single specific transmitter. The included
transmitter and receiver are bound at the factory. If
you need to rebind, follow the instructions below.
1.
Power off the transmitter and ESC.
2.
Connect a fully charged battery pack to the
ESC.
3.
Press and hold the bind button while power-
ing up the ESC. After 2 seconds the ESC will
be in bind mode.
4.
Release the bind button and power on
transmitter. Binding is complete.
You must rebind when binding the receiver to a
different transmitter.
TIP:
Use the body pin that came with your vehicle
to press the bind button within its cover.
NOTICE:
Do not attempt to bind the transmitter
and receiver if there are other compatible
transmitters in bind mode within 400 feet. Doing
so may result in unexpected binding.
