23552-1-0607
Page 34
Figure 53
Warning: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property
damage or personal injury.
Attention: Do not use Figure 53 or Figure 54 to order logs. Refer
to parts list on page 45 and parts view on page 46 to order logs
and/or ember material for your appropriate fireplace model.
Before you begin: If you are installing logs into the DVD42 or
DVD48 model then this fireplace is supplied with a set of seven
ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water
to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please
refer to
Figure 53
and
Figure 54
and corresponding WARNING
when completing following log placement steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of
firebox
4. Remove glass frame spring assembly.
5. Place front logs (#1, #2, and #3) between grates and main
burner. Align notches on front logs with locator tabs in
base.
6. Place middle log (#4) between front and rear loop of burner.
Note: do not place on top of pilot assembly.
7. Place rear log (#5) on rear log shelf. Bottom flange is to be
placed between the log shelf and burner tube.
8. Place bottom "Y" branch (#6) onto flat areas of middle log
(#4) and bottom end of "Y" branch to the back side of the
grate tang (4th one from the left).
9. Place top branch (#7) onto flat area of rear log (#5) and over
the front of "Y" branch.
10. Place decorative rock in front of grates and sides of main
burner.
ATTENTION
: Do not place decorative rock on logs or on
burner. The decorative rock should only be placed on the
fireplace floor.
11. After all logs are properly positioned, place small "dime"
size pieces of Rockwool lightly across the front burner tube
ports. Place the ember material (Rockwool pieces) side by
side. Do not stack more than one layer of embers across the
burner ports. See Figure 54.
12. Replace glass frame onto firebox.
13. Secure the two glass frame spring clamps at bottom of
firebox.
14. Align the tabs on top louver brackets with slots in front posts
to secure top louver.
15. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
1
2
3
4
6
5
7
Figure 54
1
2
3
4
5
6
7
EMBER MATERIAL
PLACEMENT
LOG PLACEMENT (7 LOG SET)
