Page 6
Operating Instructions ECR 650F-652F
1.7
Manager system
The system enables the assignment of two manager PASSWORDS. This results in access being restricted for:
1. The functions with the key in position "Z“ (reports with subsequent deletion)
2. The functions with the key in position "S/PRG" (programming)
A password is composed of four characters and the log in process is analogue to that described above. In addition, PRG
Mode can be used to restrict the following clerk rights:
•
Restriction of transactions in X mode
•
Restriction of transactions in Z mode
•
Restriction of "P/O" transactions
•
Restriction of "RETURN" transactions
•
Restriction of "VOID" transactions
•
Restriction of "NO SALE" transactions
2
Reset System, Machine Initialization
2.1
System reset
All data which has been programmed, stored in the memory, etc. is deleted!!!!
The status is displayed on the cash
register display by the character sequence "
CL
". Following this operation, the entire system is initialised, including
S Mode (refer to “Procedure for resetting the system”). The system reset is performed on changing the EPROM memory
during the initial installation, if necessary, or activated when the cash register does not respond to a warm start.
Procedure for resetting the system:
•
Turn the key to "OFF".
•
Switch the 220 V mains power supply off from the cash register, press and hold the
FEED
key
and, while doing so, switch the 220 V power supply to the cash register back on.
•
The following appear in the display
SYSTEM RESET
WARM START
CONTINUE
•
Release
the
FEED
key.
•
Turn the control key to
PRG
and then use the arrow buttons to select
SYSTEM RESET
in the display.
•
Press
CASH
: The cash register executes a
RESET
and indicates Programming Mode in the display.
•
Cancelling
the
SYSTEM RESET
: Use the arrow keys to move to
CONTINUE
and press
CASH
.
If the cash register becomes blocked (due to a paper jam, maloperation, etc.), proceed as follows:
