ECOWITT HP2552, Руководство по эксплуатации

Страница: 81 / 90

70
6 Troubleshooting Guide
Look through the following table and locate an issue or problem you are
experiencing in the left column and read possible solutions in the right
column.
Problem Solution
Outdoor sensor
not reporting to
console
Dashes (--) on
the display
console
Check that the outdoor transmission LED is flashing
normally. See
Sensor reporting interval on Section 15.
If the batteries were recently (re)placed, check correct
polarity was used and/or reseat the batteries. If the
batteries are old, replace them.
If the LED is now flashing normally, proceed to the next
step. If it is not flashing and you have repeated battery
checks and placement, you may have a defective unit.
Make sure you have fresh batteries in the display
console.
If the batteries may have been changed in the remote
and/or the console, and the console has not been reset,
the solution may be as simple as
powering cycling the
console: remove both batteries and external adapter for
about 10 seconds and reconnect.
If you still have problems, bring the outdoor sensor to a
location about 10 ft. away from the console for testing.
Power cycle the console as described above.
Do not touch any buttons for several minutes to allow the
console to “discover” the outdoor sensor. During this
process the remote sensor search icon will flash on
the display. Wait several minutes for this icon to turn off.
If the search icon turns off and the outdoor temperature
and humidity are still showing dashes (--), the remote
sensor is defective. If the sensor properly syncs up,
proceed to the next step “Intermittent problems with
outdoor sensor reception on console.”