EcoWater EASF1, Руководство пользователя

Страница: 12 / 16

12
Programming the Electronic Controller
Program Clean
Moving dashes
indicate sedi-
ment flush is
taking place
FIG. 20
Program Clean
LED (see
Table below)
2-Digit LCD
Display
(when unit is in
normal opera-
tion, shows
number of days
until next auto-
matic sediment
flush)
LED color State of LED Shows when...
Green
Blinks every
8 sec.
Unit is in normal operation
Amber On steadily
You are programming
the controller
Red
Blinks every
8 sec.
Battery is low
None
Completely
Off
Battery is dead
or disconnected
FIG. 21
POWER UP
When the controller is powered up (by installing the
battery or plugging in the optional AC adaptor), the dis-
play will briefly show the software version (example
“1.0”), then the number of days until the next automatic
sediment flush.
MANUALLY START A SEDIMENT FLUSH
After all installation steps have been completed, initiate
a manual sediment flush as follows:
1 . Press the CLEAN button and hold it for at least 2
seconds. When the 2-digit display changes to show
moving dashes (See Figure 20), release the CLEAN
button.
2 . Check drain hose to ensure a secure connection.
3 . The sediment flush sequence takes about 30 sec-
onds to complete. The flow of water to the drain will
start and stop several times.
4 . Once the sediment flush has been completed, the 2-
digit display will change to show the number of days
until the next automatic flush (or if the automatic
flush feature has been turned off it will show “- -”).
The ASF can be manually activated to flush sediment
at any time, regardless of whether or not it is set to
flush automatically.
NORMAL OPERATION
During normal operation, the LED will momentarily
blink green every 8 seconds and the 2-digit display
(LCD) will show the number of days remaining until the
next automatic sediment flush.
LCD BACKLIGHT
The 2-digit display has a backlight that goes on when-
ever a button is pressed. It goes off again after 10
seconds if no more buttons have been pressed (to
conserve battery life). Momentarily press either the
PROGRAM or CLEAN button to turn on the backlight.