ECOVACS W553, Руководство пользователя

Страница: 13 / 20

●
Turn both Winbots over and clean the Sensors with a clean Dry cloth.
●
Follower Winbot must have the adjustable handle set to the MINIMUM
setting before applying unit to window.
●
Both Winbots MUST be turned ON and the
Start Switch on the Driver Winbot depressed
to turn the electronics
ON . The Indicator
light will glow RED .
●
Taking the Follower Winbot, place it on the
outside of the Window and take the Driver
Winbot and place above the Follower Winbot on
the inside of the window and slide the two
Winbots together so they are magnetically
attracted to each other. Do
NOT let go of the
Winbots.
●
Once the two Winbots are attracted to each other, turn the Follower handle
towards the Max position until the Indicator light on the Driver Winbot
changes from
RED to BLUE . Do NOT turn the handle any further as the
magnetic attraction force is at the optimal level for this window.
5. Applying W inbots to the W indow
CAUTION : You MUST NEVER place one Winbot
DIRECTLY opposite the other on the window. The glass
could crack or shatter because of the sudden clamping
force bringing the two Winbots together so quickly.
M
in
M
ax
Min
Max
M
in
M
ax
Min
Max
Min
Max
Start
Indicator
Enjoy Smarter Life!
13
Min
Max
●
Holding the clip in one hand
,
thread the
Security Line LOOP under the FOLLOWER
HANDLE
.
Grasping the LOOP
,
slip it over
the open end of the CLIP and release then
release the spring loaded clip and make
sure it closes properly
.
●
The Security Line when assembled to the
FOLLOWER HANDLE should look like this
.
Indicator Light Indicator Light
Min
Max
Min
Max
●
After you have opened the Window
,
attached the Winbot
'
s to each
other and adjusted to the proper setting by turning the handle
,
the
YELLOW POD must be placed on the inside of the window
,
as shown
,
and the window completely closed
.