Ecostrad_Sunglo_V1.2_25062021 8
4 – 3 | Mounting Instructions
Important –
Ensure the cable is well secured so that it does not trail into the
heated area or come into contact with the reflector. The cable can be fixed to the
metal mounting bracket behind the heater with plastic zip ties.
The mounting bracket provided with the heater has been specifically designed to
allow the product to be fitted to a wall or ceiling. Before drilling the holes for the
wall or ceiling mount, please ensure that the surface is solid and that there are no
hidden water pipes or electrical wires. The heater must be installed no less than
0.4m from any side walls and no less than 1.8m from the floor.
Tools Needed:
•
Pencil
•
Hammer
•
Spirit level
•
Screwdriver
•
Power drill and drill bits
1.
Fasten the brackets (1)
together using the screws
(6), washers (5) and wing
nuts (4). (See Fig 1-2).
2.
Line up the brackets with
the wall or ceiling and
mark the location of the
four outer holes. Drill holes
at the marked locations
and fit the bolts (2) into the
holes.
3.
Thread the brackets over
the bolts and fix securely
to the mounting surface.
4.
Fasten the heater securely
to the brackets using the
screws (3).
5.
The brackets can be used
to adjust the angle of the
heater. Adjust the heater
angle by loosening the wing nuts and tighten the bolts again when the
desired angle is reached.
