ECOSTAR liftronic 500, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 40

Use protective gloves
Audible engagement
Inspect
DIL switch factory setting
2 Safety instructions
2 .1 Intended use
The garage door operator is intended exclusively for the
impulse operation of spring-compensated sectional doors
and up-and-over doors in the private / non-commercial sector.
Note the manufacturer's specifications regarding the door and
operator combination. Potential hazards as outlined in
DIN EN 13241-1 are avoided by construction and fitting
according to our guidelines. Door systems that are located in
a public area and only have one protective device, such as a
force limit, may only be operated under supervision.
The garage door operator is designed for operation in dry
areas.
2 .2 Inappropriate use
Continuous operation and use in the commercial sector is
prohibited.
The operator must not be used for doors without a safety
catch.
The operator may not be used in conjunction with timber
doors.
2 .3 Fitter qualification
Only correct fitting and maintenance in compliance with the
instructions by a competent / specialist company or a
competent / qualified person ensures safe and flawless
operation of the system. According to EN 12635, a qualified
person is a person with suitable training, specialist knowledge
and practical experience sufficient to correctly and safely fit,
test, and maintain a door system.
2 .4 Safety instructions for fitting, maintenance,
repairs and disassembly of the door system
DANGER
Compensating springs are under high tension
▶
See warning in section 3.1
WARNING
Danger of injury due to unexpected door travel
▶
See warning in section 7
Fitting, maintenance, repairs, and disassembly of the door
system and garage door operator must be performed by a
specialist.
▶
In the event of a failure of the garage door operator, a
specialist must be commissioned immediately for the
inspection or repair work.
2 .5 Safety instructions for fitting
The specialist carrying out the work must ensure that
installation is conducted in compliance with the prevailing
national job safety rules and regulations and those governing
the operation of electrical equipment. The relevant national
directives must be observed. Potential hazards as outlined in
DIN EN 13241-1 are avoided by construction and fitting
according to our guidelines.
The garage ceiling must guarantee secure fastening of the
operator. For ceilings which are too high or too light, the
operator must be fastened on additional struts.
DANGER
Mains Voltage
▶
See warning in section 4
WARNING
Unsuitable fixing material
▶
See warning in section 3.6
Danger to life from the rope
▶
See warning in section 3.6
Danger of injury due to unwanted door travel
▶
See warning in section 3.6
CAUTION
Crushing hazard during boom fitting!
▶
See warning in section 3.5
22
TR10L003-B RE / 12.2013
ENGLISH
www.thegaragedoorcentre.co.uk 0800 525 442 www.thegaragedoorcentre.co.uk