Ecoplus Pi3900 EP-1000-TAC, Руководство пользователя и инструкция по установке, Страница: 10 / 33

10
IF YOU HAVE OTHER WATER TREATMENT EQUIPMENT, YOU SHOULD DISCUSS THE
ORDER OF YOUR TREATMENT EQUIPMENT WITH YOUR DEALER PRIOR TO
INSTALLATION.
WHILE WATER LEAKS ARE VERY RARE AND UNEXPECTED, YOUR WATER FILTER
SYSTEM SHOULD BE LOCATED NEXT TO A FLOOR DRAIN OR PROTECTED BY A WATER
LEAK DETECTION SYSTEM WITH AUTOMATIC SHUT-OFF VALVE TO PREVENT WATER
DAMAGE TO YOUR PROPERTY IN THE UNLIKELY EVENT OF A WATER LEAK.
RECOMMENDED WATER LEAK DETECTION SYSTEMS ARE AVAILABLE AT WWW.A-LEAK-
DETECTOR.COM.
Step 3. – Load ecoPLUS™ Media Tank
Insert the riser tube assembly into the tank. One the end of the riser tube, there is a distributor
which looks like a cone-shaped plastic screen. There is a recess in the center of the tank to
accept the distributor to keep it properly aligned. The riser tube has been pre-cut to the
correct height for you. When the distributor is correctly positioned, the top of the riser tube
will be slightly below or flush to the top of the tank. If the tube is protruding above the top of
the tank, the distributor is not nested correctly in the recess at the bottom of the tank.
Add enough water to the tank to cover the distributor with a minimum of 12 inches of water.
This will prevent damage to the lower distributor as media is loaded. Place the funnel into
the tank so that the riser tube is in the middle. Place tape over the open end of the riser tube.
This will prevent gravel or media from accidentally going down the tube during the following
steps.
For the following steps, we recommend that you wear the dust mask provided. Take the
bag/box of gravel and, using a small scoop, add the gravel to the tank through the funnel to
completely cover the distributor. Use all of the gravel. Be sure to provide some downward
pressure on the riser tube while adding the gravel to ensure that the distributor does not shift
out of its recess or rise up. Ensure that you create an even layer of gravel across the bottom
of the tank. Ensure that the riser tube remains centered in the opening at the top of the tank.