CS-202 Wireless Contact
Specifications
Frequency: 345MHz
Operating Temperature: 32°-120°F (0°-49°C)
Battery: 3V lithium CR2032
Operating Humidity: 5-95% RH non condensing
Battery life: 5-8 years
Compatible with Honeywell receivers
Magnet gap: 5/8
th
inch max
Supervisory signal interval: 60 min(approx.)
Enrolling
To enroll the sensor, set your panel into program mode, refer to your specific alarm panel manual
for details on these menus. When prompted by the panel, trigger the sensor by moving the
magnet in and out of range of the sensor. The panel will beep when you have successfully learned
in a sensor.
Mounting
Included with the contact is double sided tape for the contact and the magnet. For reliable
bonding ensure the surface is clean and dry. Apply the tape to the sensor and then to the desired
location. Apply firm pressure for several seconds. It is not recommended to mount the tape at
temperatures below 50°F, although after 24 hours the bond will hold at low temperatures.
One side of the sensor is marked with 3 lines; this indicates the location of the reed switch. The
magnet should be mounted facing this side of the sensor, and it must be no further than 5/8 of an
inch from the sensor.
Replacing the Battery
When the battery is low a signal will be sent to the control panel. To replace the battery:
1.
Slide the top cover to disengage it from the sensor, then remove it to reveal the battery.
2.
Replace with a CR2032 battery ensuring the + side of the battery faces towards you.
3.
Re-attached the cover, ensure the Top (as marked on the inside of the cover) points away
from the battery. You should hear a click when the cover engages properly.
Note: Removing the cover will trigger a zone tamper signal to the control panel
