PowerSpout
TRG installation 2018
Last revised July 2018
© 2018 EcoInnovation Ltd (NZ)
Page 7
1.2.4.
Turbine serial numbers
All turbines have identification plates and serial numbers.
For example:
You might see 100-7S-2P-S HP F 3061 A as the serial number.
This means you have a 100 series stator, connected 7
S
eries and 2
P
arallel fingers per
phase,
H
igh
P
ower rotor upgrade, Filter installed for conducted emission compliance, invoice
number 3061 and other identical units were supplied at the same time labelled A, B, C, D
etc.
If you ever need to query an installation or order spares for a product take a picture of the
identification plate and forward it with your query. The generator code is also engraved on
the back of the PMA stator.
1.3. Safety
This section addresses safety concerns as required by international standards.
If you are not technically competent, experienced and qualified you should not install this
equipment alone and should engage the services of a suitably trained professional.
Electrical equipment can be installed or operated in such a manner that hazardous
conditions can occur; compliance with this manual does not by itself assure a 100% safe
installation. If the equipment is properly selected and correctly installed and operated
according to this manual, then any such hazards will be minimized.
The installation shall be carried out by installers with recognized and approved qualifications,
and experience relating to general electrical installations and micro-generators.
The following safety warning signs are used throughout this manual.
Caution
Risk of electric shock that could result in personal injury or loss of life
Caution
Cautions identify condition or practices that could result in damage to
equipment or personal injury, other than by electric shock.
