4
ABOUT THE CONTROLS ON THE DEHUMIDIFIER
NOTE: When the tank is full or removed, the
controls cannot be set.
ON/OFF
Press to turn the dehumidifier on and off.
FILTER
Filter indicator reminds you to check and
clean your filter.Remove the filter and clean it.
Press to turn off the Clean the Filter light. See
the Care and Cleaning section.
Humidity Set Control
The humidity level can be set within a range
of 80% to 35% RH (Relative Humidity) at
intervals of 5%.
In the LAUNDRY mode (CO)
For Laundry or continuous running, select the
LAUNDRY mode (CO), the dehumidifier will
dehumidification settings if attached to a hose
to drain or until the tank is full.
To set a lower desired humidity setting, press
press the - button and set to a lower percentage
To set a higher desired humidity setting, press
the + button and set to a higher percentage
value (%).
Display
This is an active humidistat and can adjusted to
your required levels (by using +/- button).
FAN SPEED
Controls the fan speed.
Press to select High or Low fan
speed.
Set the fan control to High for maximum
moisture removal. When the humidity
has been reduced and quiet operation is
preferred, set the fan control to Low.
Select a choice of 2 hour or 4 hour timer.
TIMER
TANK FULL Light
Glows when the tank is ready to be emptied,
or when the tank is removed or not replaced
in the proper position.
Alarm
If the tank is full or missing for more than three
minutes, an alarm will sound for about 10 seconds
to remind you to empty and replace the tank.
Auto Shut Off
The Water Level Control Switch shuts off the
dehumidifier when the tank is full, or when
the tank is removed or not replaced in the
correct position.
Auto Defrost
When frost builds up on the evaporator coils,
the compressor will cycle off and the fan will
continue to run until the frost disappears.
Auto Restart
In the case of a power outage or interruption,
the unit will automatically restart, in the settings
last used, after the power is restored.
Other Features
operate continuously at its maximum
value (%).
the humidity control to 45% or 50%.
at least 24 hours for the dehumidifier to
achieve the humidity level. If you still have
damper air than desired, set the humidity
level to a lower setting or select Continuous
for maximum dehumidification.
After the unit has stopped (Other than tank full),it
will not restart for approx. 3 minutes. This is to
protect the unit and is not a fault. Operation will
Wait 3 minutes before resuming operation
automatically restart after 3 minutes.
When you first use the dehumidifier
TIP
4H
2H
2
1
5
6
High and Low fan
indicator lights
Tank full light indicates
tank needs to be emptied
or it is not in the proper place
Laundry or Continuous
indicator light
Power On
indicator light
Clean the Filter
indicator light
4
3
4 hour or 2 hour
indicator lights
delay on/off
