Eco EHC-FH02, Инструкция по установке и эксплуатации

Страница: 26 / 39

• Proceed as described above and skip the valve operating mechanisms that
have already been coded by briefly pressing the ‘PROG’ button.
• If the LCD shows the number of a valve operating mechanism that has not
yet received a security code, press the control button on this valve operating
mechanism until ‘AC’ is displayed on the valve operating mechanism and you
hear 3 signal tones. Also see the information above.
• Now press the ‘PROG’ button on the heating control to get the heating
control to transmit the security code. The valve operating mechanism uses a
tone sequence to acknowledge that it has received the code correctly.
Afterwards, replace the valve operating mechanism’s battery compartment
cover. The valve operating mechanism uses a signal tone to acknowledge the
first receipt of a normal radio signal.
9.5. S etting the number of valve operating mechanisms (‘An A’)
You use this menu item to set the number of radiators (valve operating
mechanisms) to be controlled when the heating control is used to control
several valve operating mechanisms in one large room, for example.
If you install an additional valve operating mechanism, you must ensure that
this valve operating mechanism is assigned the same security code as the
valve operating mechanisms, which are already installed.
• Press the ‘PROG’ button until ‘Sond’ appears in the LCD.
• Use the scroller to select the special ‘An A’ function.
• To confirm your selection, briefly press the ‘PROG’ button.
• The following information is displayed:
42
e) Setting the number of valve operating mechanisms (‘
An A An A
An A An A An A
’)
You use this menu item to set the number of radiators (valve operating mechanisms) to be
controlled when the heating control is used to control several valve operating mechanisms in
one large room, for example.
Ö
If you install an additional valve operating mechanism, you must ensure that
this valve operating mechanism is assigned the same security code as the
valve operating mechanisms, which are already installed.
• Press the ‘ PROG ’ button until ‘
Sond Sond
Sond Sond Sond
’ appears in the LCD.
• Use the scroller to select the special ‘
An A An A An A An A An A
’ function.
• To confirm your selection, briefly press the ‘ PROG ’ button.
• The following information is displayed:
0
6 12
18 24
MO DI MI DO FR SA SO
Figure 34
• Use the scroller to set the number of radiators (1 to 8) and confirm your setting by briefly
pressing the ‘ PROG ’ button.
Ö
The (first) valve operating mechanism is now synchronised to the new security
code. ‘
CodE SynC 001 ’ appears on the heating control’s LCD.
Repeat the following 6 steps (see next page) for each installed valve operating mechanism:
1. Remove the battery compartment cover of the (first) valve operating mechanism by
sliding it down and out.
2. Press the button on the valve operating mechanism for approx. 3 seconds until you hear
3 signal tones. The valve operating mechanism is now ready to receive and ‘
AC AC AC AC AC
’ is
displayed.
3. Press the ‘ PROG’ button on the heating control to start transmitting the heating control’s
security code to the valve operating mechanism.
• Use the scroller to set the number of radiators (1 to 8) and confirm your
setting by briefly pressing the ‘PROG’ button.
26