Eco ECO CP-404, Руководство пользователя, Страница: 7 / 16

Submersible water pump
7
■ Paint damage due to normal wear
■ Wear parts identified by a border [xxx xxx (x)] on the spare parts list
■ Combustion motors (these are covered by a separate warranty from the manufacturer concerned)
The warranty period begins on the purchase by the first end user. Decisive is the date on the receipt. To
make a claim under warranty, please take this statement of warranty and proof of purchase to the nearest
authorized customer service center. This warranty does not affect the usual statutory rights of the customer
relative to the seller.
EU DECLARATION OF CONFORMITY
We hereby declare that this product, in the version brought into circulation by us, complies with the re-
quirements of the harmonised EU guidelines, EU safety standards and the product-specific standards.
HELP IN CASE OF MALFUNCTIONS
CAUTION!
Disconnect the mains plug before any fault rectification work! Faults in the electrical system must be
rectified by a qualified electrician.
Malfunction Possible cause Solution
Motor does not run. Impeller blocked. Remove dirt in the suction area. Clean with
a suitable tool through the opening at the
back of the motor housing.
Thermal protection switch has
switched off. Wait until the thermal protection switch on
the immersion pump switches on again.
Take note of the maximum temperature of
the
conveying medium. Have the
immersion pump inspected.
No mains power. Check the fuses, have the power supply
checked by a qualified electrician.
Float switch does not switch off
when the water level rises. Send the immersion pump to a service
facility.
Pump running but
does not feed.
Air in pump housing. Vent the immersion pump by holding it at
an angle.
Blockage on the suction side. Remove dirt in the suction area
Pressure line closed off. Open the pressure line.
Pressure hose kinked. Extend the pressure hose.
Feed head to high. Hose diameter too small. Use a bigger pressure hose.
Blockage on the suction side. Remove dirt in the suction area.
Feed head to high. Observe max. feed head, see technical
data
If the faults cannot be rectified, please contact our customer service department.