נד
א
ו
ר
מ
ע
כר
ו
ת
ת
א
ט
ר
ון
ו
א
ו
ל
פ
נ
י
ם
עב
"
מ
|
09-7444222
|
www.danor.com
|
5
Prevent burning or fire
1. The fixture can be mounted directly on the surface of ordinary combustible material.
2. Do not short-circuit temperature protection switch or fuse, use the specified type of fuse.
3. The equipment must be installed away from inflammable and explosive materials.
4. The equipment should be projected range of 3 meters away objects and projectiles
temperature less than 60 ° C; ---- 3.0m.
5. Fan or ventilation, at least in the range of 0.5 meters can not be an obstacle.
6. Do not place any object on the lens.
7. Handling at least allow the device to cool for 20 minutes.
8. Do not replace the non-original parts.
Transport protect lock
In order to protect the light, the device counts with a vertical lock to stop from unwanted
movement, during the transport, the lock must remain close keeping the item safe.
About Packing
1, Before save the device, make sure the power is off and wait for at least 10 minutes to cool it
down.
2, Before clean the lens, make sure X,Y axis are in good condition.
3, After pack it by a plastic bad, carry and move it using it the two handles besides the product
and put the product into the fly case up-side-down.
4, After the product have been packed, put the accessory into the case and close and lock the fly
case.
Unpacking
Note: before unpacking check the damage is whether due the transportation or not, if you find
any such damage, please don’t use this item, and contact with the dealer.
1, Open the fly case and take out the inside plastic bag.
2, High-lift the product by two handles beside the bottom base and move it out.
3, Make sure you have opened the X,Y axis and after the power on the unit.
