ECO Spot LED80 User Manual
Handling Instructions
Warranty
One Year from Date of Purchase
Lamp Replacement
Under normal circumstances, the LED lamp will not need to be replaced over the lifetime
of the projector. If it should fail, the projector will need to be sent in for service.
Focusing
•
Power up the projector by pressing the larger switch in the back.
•
Turn on the gobo rotator with the smaller switch in the back and switch it off when
the gobo projects in the desired position.
•
Focus the projection by twisting the lens in and out until the image is well focused.
When used for the first time, the lens will often need to be twisted many rotations to
reach the focusing point. This can take up to three minutes.Gobo Rotator
•
Before the initial start-up, please unpack and carefully check for damage caused
during transportation.
•
Place your fixture at a suitable place with good air flow.
•
Make sure there are no flammable materials close to the lamp.
•
Depending on the ambient temperature, the lamp may need up to 60 sec. to start.
•
When suspending the fixture above ground level, verify that the structure can hold at
least 10 times the weight of all installed devices.
•
Verify that all external covers and rigging hardware are securely fastened and use an
approved means of secondary attachment such as a safety cable.
•
Turn on and off the gobo rotator with the switch on the back plate
•
There are no controls for rotating speed or direction.
Page 2
Copyright © 2014 Globus New Media LLC
