ECO Spot LED B90E/B150E/B300E User Manual
Copyright © 2015 Globus New Media LLC
Page 3
Multi-functional Yoke
Gobo Placement
The Projector uses M-Size gobos, (see
Specifications
for Gobo Dimensions).
The yoke can slide over the fixture body to accommodate a wide range of pointing
directions. It can serve as stand or can be mounted to a wall, ceiling or truss.
•
Pointing position UP: With the long-hole pointing towards the back of the
projector, the main pointing position is UP.
•
Pointing position DOWN: Remove the yoke screws and flip the projector so the
long-hole points to the front plate.
•
If the projector is on, turn it off.
•
Even though this is a LED projector, the gobo gets hot, please wait a few minutes
for the gobo to cool down if the projector was on.
•
Unscrew the thumbscrews to remove the front cover with the projection lens.
Keep the rubber seals and re-use them with the thumb screws to prevent leakage.
•
Push the two pins of the gobo retaining ring together and pull out the retaining
ring. Carefully remove the old gobo and replace it with the new gobo.
•
If you have a glass gobo, place the more reflective side towards the light bulb.
•
Replace the retaining ring and make sure it evenly pushes the gobo all the way
back.
•
Replace the front cover and rubber seals and tighten the thumb screws well.
•
Adjust the focus by twisting the projection lens in or out.
•
Re-tighten the lens retaining ring towards the front plate so the silicone ring
makes a water tight seal.
