
42
Appendix B: Module EIB Mode and Stand-alone Mode
The NOxCAN module can be used in conjunction with a display head (EIB mode) or on its
own (Stand-alone mode). When delivered to be used with a display head, the module is setup
in EIB mode. When delivered to be used alone, the module is setup in Stand-alone mode.
In EIB mode, the module communicates to the display head via a special high-speed
communication protocol. The module must be EIB mode when on the EIB with a display
head. When in Stand-alone Mode, the module communicates via the common 500 kHz CAN
broadcast protocol.
The module must be properly configured in EIB mode or Stand-alone mode depending on
how it will be used.
To convert from one mode to the other requires software reprogramming of the NOx module
(using the Configuration Tool) followed by the removal (set to EIB) or installation (set to
Stand-alone) of a jumper inside the module.
To convert a module from Stand-alone to EIB Mode
(Note: Lambda module shown in pictures but procedure for NOx module is identical)
1.
Connect the NOx module to a power supply and a PC (via a CAN communication
adapter) using the cabling shown below. A sensor does not have to be connected to
the module. Note that only one module is connected and the display head is not
involved.
Figure B1: NOxCAN Module prepared for Reprogramming
P/N 11-02, DC Power Cable,
DB9F, Banana Plugs (shown), or
P/N 11-01, DC Power Cable,
DB9F, Spades
To power
To CAN adapter
on PC
Resistor
“T”
Module Serial
Number
Содержание NOx 5210 Series
