Eclipse EC-P10, Руководство пользователя

Страница: 36 / 44

36 P0016-LU-02.01
4. Touch-Tone Remote Control
Introduction
The EC-P10 onboard communicator can be used to remotely control your alarm via any
touch-tone telephone. Once the call is answered by the control panel you will be assisted by
voice prompts to enter your normal access code, if the code is accepted a voice prompted
menu is played to you. From the main menu you can arm and disarm the system and turn
outputs on and off.
Remote Control Menu
Function Touch-Tone Command
Away Arm
*1#
Stay Arm (1)
*2#
Disarm
*0#
Playback Speech Messages
*7?#
(? = 1 to 4)
Record Speech Messages
*8?#
(? = 1 to 4)
Turn Remote Control Outputs On or Off
*9?#
(? = 1 to 5)
Play main menu
*#
End Call
*99#
Remote Access
To gain remote access to your alarm system, please proceed as follows:
1. From any touch-tone telephone, first dial the number of your premises. If your premises
have more than one line, be sure to call the number of the line on which your EC-P10
control panel has been installed. After a single ring, hang up, wait 10 seconds, and call
again. On the second call, the system will answer after one or two rings and announce:
“Enter passcode.”
2. Enter your normal access code within 5 seconds or the system will attempt to answer
the call in modem mode (you will hear a high pitched tone). The system will then
prompt the current status:
“System Disarmed” or “System Armed” or “System Stay Armed”
3. The main menu is prompted:
“Press 1 to away arm, press 2 to stay arm, press * to hear again.”
4. Enter the function command (see remote control menu).
5. To end the remote access session, enter
*99#
on your touch-tone phone.