Eclipse 650, Быстрый старт, Страница: 10 / 16

10 / 16
LED
Binding Instructions
Binding is the process of programming the receiver to recognize
the GUID (Globally Unique Identifier) code of a single specific
transmitter. When a receiver is bound to a transmitter, the
receiver will only respond to that specific transmitter.
The Eclipse 650 comes with bound Transmitter and Receiver.
If you need to rebind for any reason, please follow these steps:
1. With the transmitter switched OFF.
2. Power on the receiver, then turn on the transmitter within 5
seconds.
3. The receiver LED will blink from 3-5 seconds while binding
automatically.
4. When the LED stops flashing, binding is complete and the
Eclipse 650 is ready to run.
Antenna
Loosen this screw
Power - Channel ELEV
Rudder Stick - Channel AILE
Sail Stick - Channel THRO
24. Move the bowsie attached to
the main sail grommet to tighten
or loosen the main sail.
26. Loosen the screw on the
arm of the main boom to
adjust the height of main
boom. This adjustment is
typically not needed.
25. Move the bowsie on the
main sail backstay rigging to
maintain a slight bend in the
mast. The dotted line in the
drawing to the far left is an
exaggerated example of what
the bend should look like.
The actual bend should be
less pronounced than the
drawing shows.