Ecler NPA2500T, Руководство пользователя

Страница: 12 / 52

12
•
ADVANCED menu
Amplifier advanced features:
o
LCD CONTRAST : adjusts the LCD contrast.
o
FINDER : enables / disables the display backlight flashing, useful to identify a physical unit with
its virtual equivalent in EclerNet Manager software (see EclerNet Manager manual for more
information).
o
INFO : shows the amplifier model and firmware version.
o
NETWORK : allows setting IP address, mask and gateway for the amplifier Ethernet interface
(The default port is 2210. You can not change it with local controls, but with EclerNet Manager
software only).
o
POWER ON MODE : allows selecting the amplifier behavior at power-up (POWER switch on
the rear panel). The amplifier can start up in STANDBY mode, ON or recover its last status
before the last power supply interruption, for example in the event of a mains power recovery
after a mains power failure (
LAST STATE ).
o
RESTORE : allows resetting all amplifier parameters to their default value, except the
cumulative operating time (erases passwords, PRESETS , DSP parameters, setup settings,
alarms counters and Ethernet network setup).
o
PASSWORD : allows assigning the amplifier a user or administrator password.
•
USER : once this password has been set, the unit will request it each time you try to
use any control or adjustment in the amplifier setup (on, off, volume adjustment and
access to menus).
•
ADMIN (administrator): once this password has been set, only main screen controls
can be used: power on, power off, volume adjustment and muting. To adjust the
amplifier setup (access to menus,
MENU key) the password is requested.
Note: To disable a password you need to rewrite it with a blank one.
Most functions described above have their equivalent in EclerNet Manager software. Please refer to the
EclerNet Manager software manual for more information.
5. CLEANING
The front panel should not be cleaned with dissolvent or abrasive substances because silk-printing could
be damaged. To clean it, use a soft cloth slightly wet with water and neutral liquid soap; dry it with a clean cloth. Be
careful that water never gets into the amplifier through the holes of the front panel.