7
5.
CONNECTIONS
The connection terminals for models IC6 and IC8 are of the pressure clamp type
for bare cable. Once connected, just select the mode and working power of the unit
with a simple screwdriver. Always respect the polarity.
IC6 Connection plate
In the IC3 model, the connection terminals are screw-type terminal blocks.
Connect the cables as follows:
•
Between "0" and "8 / 10W" terminals (negative and positive, respectively) if
your amplifier is of low impedance
•
Between the "COM" terminals and "6W or 3W or 1.5W @ 100V" (negative
and positive, respectively) if your amplifier is of high impedance, thus
directly selecting a working power for the IC3 unit
The IC series are shipped from factory with the switch in 100V/70V position.
If it is connected to a low-impedance amplifier, the speaker will not be
damaged, but will perform way below its full potential. If the speaker is
accidentally connected to a 100V/70V line in the 8
Ω
position, it will be
severely damaged.
The installation of each unit is easily carried out using the 3 rotating tabs
incorporated in models IC6 and IC8, and spring clamps in model IC3. For more
information on the installation method, see section 5 of this manual.
